STEP-BY-STEP GUIDE

1. Prepare the area and empty your bladder

• Start in the bathroom with good lighting.
• Empty your bladder completely.
• Shake out every drop before beginning.
• Important: any remaining urine droplets can cause a leak.

2. Gather supplies and allow enough time

• Your first order includes two gift tips so you can practice before opening the main package.
• Use the practice tips first; opened packages cannot be returned or refunded.
• Plan for about 10 minutes total so you do not rush the process.
• You will need:
• 2 skin prep pads
• 1 Jiftip
• 1 removal cream

3. Clean the skin thoroughly with both prep pads

Do two pre-soaks and two cleanings using both pads.

• Keep each pad folded so it stays wet longer.
• Use gentle circles around the head during the pre-soak.
• Do not rely on showering alone; the skin must be tip-cleaned.
• Rushing the application is the most common beginner mistake.

4. First pre-soak and first cleaning

• Start with the first prep pad.
• Pre-soak: massage gently in circles around the head for 1 minute.
• First cleaning: refold the pad to expose a fresh surface and clean for 2 minutes.
• Refold every 30 seconds to keep using a clean section.
• If the pad dries too quickly, spray with IPA alcohol.

5. Second pre-soak and second cleaning

• Open the second skin prep pad.
• Repeat the process: 1 minute second pre-soak
• 2 minutes second cleaning

Continue gentle circular motions.

Keep the wipe folded so it stays wet longer.

Refold every 30 seconds for a fresh surface.

6. Use the right alcohol and finish drying

• Keep a spray bottle of 99% rubbing alcohol in your kit.

Use IPA alcohol, not ethanol.

• Recommended range: 75% to 99% IPA.
• 75% stays wet longer
• 99% dries faster and cleans better
• Finish by drying the skin completely:
• Blow dry for 1 minute, or
• Fan dry for 2 minutes
• The skin must be clean, oil-free, and 100% dry before application.

7. Apply the Jiftip tip to cover just the tip

• Open the sterile packet and remove the Jiftip.
• Peel off the glue cover.
• Center the tip over the urethra opening.
• Spread the frenulum channel open and press the shield down.
• Peel the second glue cover and press down the other side.
• Flatten the head with a stiff finger.
• Roll your finger side to side to press the edges down without wrinkles.

8. Let the bond set and avoid peeling

• Gently roll the head against your palm for 2 minutes to help the skin bond.
• Let the backing material fall off by itself.
• Do not peel it off, or you may need to start over.

9. Enjoy the one-size-fits-all comfort

• Once applied, the tip is secure and does not slip.
• The intended experience is skin-on-skin without condoms.

10. Remove the Jiftip tip with cream

• Everyone forget its there. Very painful when you try to urinate.
• So pop the bubble and drain first.
• Add the removal cream to the shield and massage slowly.
• Continue until the shield falls off.
• If you want to delay shield removal until the next day. You will enjoy a 2nd happy ending.

11. Use the discount code

• Use the discount code on your first order, its your diploma from the Jiftip Academy.

Inside my Jiftip kit:

• Small spray bottle with IPA isopropyl or rubbing alcohol.
• 75 to 99% all work fine.
• Purchase online or at your favorite pharmacy. e.g. Walmart.com